As with all e-flite ARF’s all hardware is supplied. No modifications necessary, although I do recommend going over weak spots with either thin CA or epoxy as you see fit. Spots get missed in the factory.

The covering is nice, wrinkles always seem to be there though I can have Eli show me how to work them out. //*//UPDATE – wrinkles cleaned up quite well with a heatgun.

There is room to neatly route cables, always a plus. The battery compartment can accomadate nearly any 3s or 4s lipo.

Hinging is required for all control surfaces.

Basic shop tools used, nothing fancy.

For this build I will be using the following gear:

E-Flite power 32 motor, 770kv, on 4s lipo

Castle Phoenix 60 ESC + Castle BEC

4x JR Sport MN48 Servos

Spektrum AR7000 RX w/Flight Log

APC 12 x 8 & 13 x 6.5 e-props w/e-flite aluminum spinner

Dual ailerons configured in TX. It will be flown by a JR X9303 DSM2 radio.

OK some pics already, I was in a rush to build so started right into it.

RX installed

ESC & BEC

M0Tar

Getting there

Wow it's purple

And done! Fairly aggressive control surfaces

If I had not slacked towards the end of the project, it could have been completed in a few nights time, given a few hours each night.

The ailerons were a pain to hinge, then again I always dislike hinging. This involves patience and careful application of thin CA to the hinges. I ended up with minor mis-alignment on each aileron due to the pre-done hinge slots in the wing not aligned. //*//UPDATE//*// Eli has since used his heatgun to tune the ailerons, no more twists!

After hinging the horizontal & vertical stab, they both installed quickly and accurately after checking alignment. Thin CA was used to wick into the fuse after the covering was neatly cut.

Servos installed with no problems using the stock JR hardware included, + some 12″ extensions. I did use the special long servo arms from JR, and the stock e-flite pushrods, etc. Topped it off with Parsons retainer clips where the servo extensions join.

The hatch simply requires careful alignment and the use of canopy glue to apply the canopy. It should sit for a few hours at least before handling.

The power 32 motor bolts right up to the firewall using the included hardware – no spacers needed for the shorter motor (as opposed to the power 25).  There’s room to neatly mount the ESC / BEC and route all cables to the battery compartment / receiver area. I used some spiral wrap to keep things outta my way.

The one-piece wing is a snap to install – and bolted in via a single large nylon bolt.

Given careful alignment and markings for the pin drill, the cowl is a simple job. I’d drop some thin CA into the pilot holes you drill for the cowl screws to add some strength.

Overall, this was a fun project, and definately a quality ARF.

If you want to check out the manual, it is here

-Zeke